Yokogawa Clamp-on Power Meter CW10[Product print page]

Manufacturer: Yokogawa Electric Corporation

Yokogawa Clamp-on Power Meter CW10 

The Clamp-on Power Meter CW10 (Single-Phase) is more like a tester type rather than a recorder, which can measure single phase AC and DC Power, Voltage, Currents, Power Factor, Frequency, Harmonics. It will also contribute to workers maintenance of not only consuming equipment but also equipment for renewable energy, such as solar and wind power generation. 

Yokogawa Clamp-on Power Meter CW10

General Specifications

Display count: 9999 / 6000
Measuring rate: 3 times / sec.
Over range indicator: “OL” or “-OL”
Auto Power Off: Approx. 15 minute.
Low-battery indicator: four steps
Power supply: 9V alkaline battery (6LR61)
Battery life: When using alkaline battery, backlight off approx. 20 hours
Operating temperature and humidity:
                 0 to 50 °C (with no condensation)
                  ≤ 80% RH (0 to 30 °C)
                 ≤ 75% RH (30 to 40 °C)
                  ≤ 45% RH (40 to 50 °C)
Temperature coefficient: At 0 to 18 °C and 28 to 50 °C
                                       Add 23±5 °C accuracy × 0.2 / °C
Storage temperature: -10 to 50 °C, 80% RH or less (remove the battery)
Withstand voltage:
                    AC 6880 Vrms 5 seconds (between the core and the case)
                    AC 4300 Vrms 5 seconds (between the core and the voltage input terminals)
                    AC 6880 Vrms 5 seconds (between the voltage input terminals and the case)
Insulation resistance: 100 MΩ or greater at 1000 VDC (between the core and the case, the core and the voltage input terminals and the voltage input terminals and the case)   Yokogawa Clamp-on Power Meter CW10